smartron t-phone p imei repaire done with umt

GSM-Forum

smartron t-phone p imei repaire done with umt

smartron t-phone p imei repaire done with umt
Operation : Repair IMEI
Searching for Device in FTM Mode...Found
Port : Handset Diagnostic Port (COM145)
Hardware ID : usb\vid_19d2&pid_0213&rev_0318&mi_00
Compile : Jan 30 2018 16:31:00
Release : Dec 10 2017 23:00:00
Hw. Ver. : 8940.gen
Software : SMA_IN_P840F12_V1.0.0B06
IMEI : 911593950386195 / 911593950396194
Reading QCN Data...Done
Saved As : C:\UMTool\QcFire\QCN_Backup\8940.gen_SMA_IN_P840F1 2_V1.0.0B06_911593950386195_180811_151924.qcn
Switching to EDL Mode...Done
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM90)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.2.2
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Hardware ID : E1B00600 [8937] 00000400
OPK_DATA : C7EF5E9C6DE5335E2E3B54BF2C47DFF605D327262E03B79E51 5436BF642B09F4
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Firehose Loader...Done
Sending Loader [8937_017.ufl]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8937, eMMC, 32 GB
LU Count : 1 [0x03A3E000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : ZTE T5211 [msm8937]
Software : T5211INDURA-02, 20180130.170442 [2018年 01月 30日 星期二 17:04:42 CST]
Android Ver. : 7.1.1
Patch Level : 2017-12-01
Saving EFS Backup.......OK
EFS Backup : EFS_ZTE_T5211_T5211INDURA-02_2017-12-01_180811_152134.ueb
Reset EFS (Full).......Done
Port : COM145 : Handset Diagnostic Port (COM145)
Processing background tasks...Done
Restoring QCN Data...Done
Finalizing process...Done
Operation Finished.
Module Ver. 2.6